Anchor Pool Cover Measuring Instructions User Manual download pdf

1. SKETCH Begin with a freehand sketch indicating the inside pool edge (water edge). Include in your sketch the

deck area, planters and any obstructions within 3 feet of the pools waterline. Photos of pool are required as indicated

below.

2. A-B POINTS - See Figure 1 Establish two points to be referred to as “A-B” points. The “A” should be

on the left and the “B” on the right while facing the pool (If A and B points are ﬂ ipped the cover may be made upside

down). The “A-B” line must be at least 3 feet away (the further away, the better) from the water’s edge of the pool

and 2/3 the length of the pool; the longer the “A-B” line, the better. (show your “A-B” points and their location on your

sketch).

3. A-B MEASUREMENTS

A. POOL:

● Using chalk, mark and NUMBER points along the water’s edge of pool at approximately 3’-0” intervals

or less for tight radius areas (4 foot radius or less) use intervals of 6 inch to 1 foot apart. All corner/direction

changes must be marked and numbered.

● Measurements are then to be taken from point “A” to point #1, then point #2 and so on to each numbered

point around the pool. Then measure from point “B” to point #1, then point #2 as previously done for point “A”.

Measurements are to be rounded to the nearest inch and listed in column format as shown in the example.

B. SPECIAL FEATURES / OBSTRUCTIONS:

● Using chalk, mark and LETTER points that include all corner/direction change, ladders, handrails, grab

rails, slide legs, rocks, spillways, spa walls separating spa and pool, ﬁ ll spout and dive stand. These areas

require closer intervals of 6 inches to 1 foot apart. At least 3 points should be marked and given along

straight walls.

● Measurements are then to be taken from point “A” to Letter A, then Letter B and so on to each Lettered point

around the pool. Then measure from point “B” to Letter A, then Letter B as previously done for point “A”.

Measurements are to be rounded to the nearest inch and listed in column format as shown in the example.

4. FOR QUOTING Measure to the longest length and widest width of the pool between two known points and

record these measurements and points in table.

5. CROSS REFERENCE DIMENSIONS Measurements are to be taken for reference of the length and

width between two known cross points and recorded in table. Additional measurements are suggested for more

difﬁ cult or custom pools (three width & two length). Cross dimensions to any obstacles or complicated areas is also

recommended.

POOL COVER

MEASURING INSTRUCTIONS

NOTE: The “A-B” line must never cross the pool line and should be at least 3 feet away from the pool at the closest

point.

IMPORTANT NOTE: Failure to provide all information requested will extend the order process and may result in return

trips to the pool for further information.

IMPORTANT NOTES:

● ALL A-B MEASUREMENTS MUST BE MEASURED AT THE SAME ELEVATION (See Appendix C)

● Indicate on diagram where there is less than 3 Ft. of Decking.

● Use of stakes over 10 ft. in continuous length or over 10% maximum perimeter of cover does not meet ASTM

standards for safety cover.

● Please mark any obstruction measured that is not on water line with LETTERS A, B, C….

1100 Burch Dr. • P.O. Box 3477

Evansville, IN 47733 U.S.A.

Ph. (812)867-2421

Fax (812)867-1429

E-mail: [email protected]

PCMI 0812EC4572

1 2 3 4 5 6 ... 13 14

Summary of Contents

Page 1 - MEASURING INSTRUCTIONS

1. SKETCH Begin with a freehand sketch indicating the inside pool edge (water edge). Include in your sketch the deck area, planters and any obstruc

Page 2 - FOR REFERENCE ONLY

10Cable ConstructionPool EdgePool EdgeAB121516 17111314Figure B-1SPA WITH CABLE CONSTRUCTIONDealer Name____________________________Customer Name _____

Page 3 - PROVIDE SKETCH OF POOL BELOW

11Web with Ratchet - Need distance around spa to determine length of web with Ratchet.Pool EdgePool Edge131819201716151412FBAGEDCFigure B-3 SPA WITH W

Page 4 - A-B TABLE

12Figure C-1 RAISED AREAS OR VARYING DECK LEVELSAB1. PHOTOS REQUIRED FOR EACH RAISED AREA OR VARYING DECK LEVEL.A. For Raised Walls - See Figure C-1

Page 5 - Appendix B

13Appendix D - Negative EdgeA. PHOTOS REQUIRED.B. See Figure D-1 for additional instructions for measurement requirements. C. Indicate construction

Page 6 - Appendix D

14Appendix EA-B TABLE cont’dREFERENCE DIMENSIONS

Page 7 - APPENDIX

2Figure 1FOR REFERENCE ONLY.

Page 8 - Figure A-3

3FAILURE TO PROVIDE ALL INFORMATION REQUESTED WILL EXTEND THE ORDER PROCESS AND MAY RESULT IN RETURN TRIPS TO THE POOL FOR FURTHUR INFORMATION. PROVID

Page 9

4FAILURE TO PROVIDE ALL INFORMATION REQUESTED WILL EXTEND THE ORDER PROCESS AND MAY RESULT IN RETURN TRIPS TO THE POOL FOR FURTHUR INFORMATION. 

Page 10 - SPA WITH CABLE POCKET

5REQUIRED INFORMATIONCircle Correct Answers.Fill In applicable blanks.Dealer Name____________________________Customer Name _________________________Da

Page 11 - SPA WITH WEB IN POCKET

6REQUIRED INFORMATION CONT’DCircle Correct Answers.Fill In applicable blanks.Dealer Name____________________________Customer Name ____________________

Page 12

7APPENDIX15CAB141312111617Height (must not exceed 18”)WedgeWedgeTye clipWedge ClipsDive RockReinforcement at Reinforcement at rock edges.rock edges.Po

Page 13 - CABLE ALONG BACK

81514Figure A-2DIVE ROCK WITH CABLE CONSTRUCTIONDive RockOverhang Distance16171819ABCCable ConstructionDive RockWeb with Ratchet - Need distance aroun

Page 14 - A-B TABLE cont’d

9Dealer Name____________________________Customer Name _________________________Date___________________________________Appendix B - Spa Cover1. PHOTOS

Comments to this Manuals

No comments

Anchor Pool Cover Measuring Instructions User Manual

Browse online or download User Manual for Accessories for water Anchor Pool Cover Measuring Instructions. Anchor Pool Cover Measuring Instructions User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories for water Anchor Pool Cover Measuring Instructions