Anchor CLASSIC SOLID SAFETY POOL COVER GROUND TUBES AND S User Manual download pdf

GTP 1013

INSTALLATION INSTRUCTIONS FOR

EC4734

GROUND TUBES

Water in pool

Pool Cover

Ground tube

Water in pool

Do not angle pool cover ties or springs down to

soil level. Spring or Tie may ﬂ y off. Soil must

be built-up to deck of pool level.

Always place stake or ground tube as close to

pool deck as possible.

Pool Deck

Pavers

Setting

Bed

Pool Deck

Earth

Pavers. Drill 1” diameter hole thru paver for

ground tube. Top of ground tube must be ﬂ ush

w/top of paver. IMPORTANT: Do not install

Ground tube in ﬁ rst row of pavers adjacent to

pool.

Figure 1

Figure 2

Figure 3

Top of ground tube must be flush

with top of ground.

Spring or tie

Ground tube

Earth

Spring or tie

Important: Consult paver

manufacturer for drilling

recommendations.

Pool Deck

Inspect Site!

Caution:

1. Consult your local utility locator service or the

National Utility Locating Contractors Association

(NULCA) prior to installation.

2. Consult design information on pool for plumb-

ing/electrical line placement.

1. For each installation the installer is solely

responsible for evaluating the site and determin-

ing the proper method and equipment to secure

the cover. Some soils require different staking or

securing than that provided with the pool cover.

Due to this variety of soil conditions, the installer

must insure proper anchoring at each anchor

point.

2. This instruction sheet must be used along

with the pool cover installation instruction manual

included with your pool cover.

3. The soil at the installation site of each ground

tube must be capable of allowing the cover to

support the minimum loads of ASTM F-1346 after

installation.

4. Testing of soil conditions and responsibility for

load veriﬁ cation is solely the responsibility of the

installer.

One ground tube per tie or spring.

GROUND TUBE IN SOIL

GROUND TUBE THRU PAVERS

1’-3”

9”

Pool Cover

1 2

Summary of Contents

Page 1 - GROUND TUBES

GTP 1013INSTALLATION INSTRUCTIONS FOREC4734GROUND TUBESWater in poolPool CoverGround tubeWater in poolDo not angle pool cover ties or springs down to

Page 2 - 812.867.2421

1. Remove Brass Anchor screw from Brass Anchor.2. Place Brass Anchor into Counterbored end of Ground Tube.3. Stand Ground Tube up on Firm Surface.

Comments to this Manuals

No comments

Anchor CLASSIC SOLID SAFETY POOL COVER GROUND TUBES AND S User Manual

Browse online or download User Manual for Accessories for water Anchor CLASSIC SOLID SAFETY POOL COVER GROUND TUBES AND S. Anchor CLASSIC SOLID SAFETY POOL COVER GROUND TUBES AND STAKES User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories for water Anchor CLASSIC SOLID SAFETY POOL COVER GROUND TUBES AND S