MESHPC 1013INSTALLATION INSTRUCTIONS EC47341100 Burch Dr. • P.O. Box 3477 • Evansville, IN 47733 U.S.A.Ph. (812)867-2421Fax. (812)867-1429E-mail: cu
10INSTALLING BRASS ANCHORS AT CORNERSFIG. 390º90º1”1”STEP 8: INSPECTION AND CLEAN-UPCALL ANCHOR POOL COVER SALES @ 1-800-255-5552TO CLARIFY INSTALLAT
111. Before tightening the pool cover anchors near the steps, tuck step wedges under the overlap edge of the cover, as needed. 2. Pull the outer edg
12STEP WEDGEZIPPER FOR STUFFING WITH DUNNAGEFLAPS FOR CLIPPING TO COVERSTEP 9C INSTALLING STEP WEDGESTYE CLIP INSTALLATIONCOMPLETE STEP COVERING, WIT
13IMPORTANT NOTE: Installation of pool cover must begin at any areas with cut-outs or zero tolerance areas (such as at cable-construction). When ther
14OPTIONAL CABLE ASSEMBLY INSTALLATION3/16” STAINLESS STEEL CABLETURNBUCKLECABLE CLAMP3/8” SLOTTED CABLE ANCHOR BOLT -DROP IN ANCHOR3/8” MACHINE THREA
FIG. 4Drilling/Setting of 3/8” Drop-in AnchorsFIG. 5ARAISED WALLCABLE CLAMPSCABLE CLAMPSEYEBOLTENDHOOKENDCABLECABLECABLECOVERSNAPWEATHER FLAPCABLE ANC
EVANSVILLE, INDIANAThank you for purchasing an Anchor product. In return, we pledge Quality, Service and Craftsmanship and are available for any ques
2Contents Warranty...
3ANCHOR SAFETY POOL COVERWARRANTY To whom does the Limited Warranty apply? This Limited Warranty is extended to the original consumer purchaser only,
4INTRODUCTION:Thank you for your recent purchase of an Anchor Industries Inc. quality Mesh Safety Pool Cover. With proper installation and care, your
5STEP 1:TOOLS & HARDWARETools Required For InstallationRotary Hammer Drill Hammer 3/4” Masonry Bit Block of wood Tape Measure 5 Gallo
6STEP 2:PREPARE POOL FOR INSTALLATION1) It is best to have water at operating level to install pool cover. Do not lower water more than 15” below
7STEP 4: ALIGNING POOL COVER1) Once cover is unfolded across pool, line up cutouts for ladders, slide legs, etc. and/or cable areas. Be sure t
8STEP 6: LOCATING/SETTING BRASS ANCHOR & FASTENING SPRINGS1) Brass anchors are placed approximately 1-5” from pool cover edge, (have cover as tau
91) To remove, hold the spring tool so that the notch is facing away from the pool and insert it into the spring which encircles the open brass ancho
Comments to this Manuals