Anchor CLASSIC SOLID SAFETY POOL COVER User Manual

PCSO 1013INSTALLATION INSTRUCTIONS EC47341100 Burch Dr. • P.O. Box 3477 • Evansville, IN 47733 U.S.A.Ph. (812)867-2421Fax. (812)867-1429E-mail: cust

10INSTALLING BRASS ANCHORS AT CORNERSFIG. 3STEP 7:PLACEMENT OF PUMPCALL ANCHOR POOL COVER SALES @ 1-800-255-5552TO CLARIFY INSTALLATION INSTRUCTION QU

11STEP 9: STEP WEDGESINSTALLING STEP WEDGES1. Before tightening the pool cover anchors near the steps, tuck step wedges under the overlap edge of th

12• Determine best placement for Tye Clip Assembly.• Install Brass Anchor butted up next to edge of pool cover.• Assemble the Tye Clip as shown in d

13IMPORTANT NOTE: Installation of pool cover must begin at any areas with cut-outs or zero tolerance areas (such as at cable-construction). When ther

14OPTIONAL CABLE ASSEMBLY INSTALLATION1) Install 3/8” drop-in anchor with 3/8” eyebolt on one end of cable area. Install 3/8” drop in anchors at the

Drilling/Setting of 3/8” Drop-in AnchorsEMBEDMENT3/8” Drop-inDrill Diameter - 1/2”Minimum Depth - 1 7/8”1) Drill a hole into base material to the dept

EVANSVILLE, INDIANAThank you for purchasing an Anchor product. In return, we pledge Quality, Service and Craftsmanship and are available for any ques

Contents Warranty...

3ANCHOR SAFETY POOL COVERWARRANTY To whom does the Limited Warranty apply? This Limited Warranty is extended to the original consumer purchaser only,

4INTRODUCTION:Thank you for your recent purchase of an Anchor Industries Inc. quality Solid Safety Pool Cover. With proper installation and care, you

5STEP 1:TOOLS & HARDWAREIt is recommended that at least (2) individuals install a cover.Tools Required For InstallationRotary Hammer Drill3/4” Mas

6DECKUNFOLD LEFTUNROLL TO RIGHTDECKCOVERBUCKET(TYP.)UNFOLD TOWARD THIS END OF POOLSPASTEP 2:PREPARE POOL FOR INSTALLATION1) It is best to have water l

7DECKCOVERPOOL EDGERUBBER TIE(TYP.)CABLESPASTEP 4:ALIGNING POOL COVER1) Once cover is unfolded across pool, line up cutouts for ladders, slide legs, e

8STEP 6:LOCATING/SETTING BRASS ANCHORS & RUBBER TIES1) Brass anchors are placed approximately 11” from pool cover edge. 1a) Rectangular Pool Co

9INSTALLING 1) When fastening tie, brass anchor screw should be in open position (unscrewed approximately 1/2”). Take end of tie and place on