Anchor STAKE OUT User Manual download pdf

ASO 1208

Assembly and Operation Instructions

EC 3845

Step 1: Place contents

of box on floor or table. Place

handle over riser tube with de-

cal facing up and insert short

3/8” - 24 bolt.

Step 2: Start 3/8” - 24

self-locking nut onto bolt.

Step 3: Swing link arms

up to handle. Insert the long

3/8” bolt through link arms and

handle.

Step 4: Use two 9/16”

wrenches to tighten riser bolts

and nuts and link arms onto

handle.

Note: Nut will stop before

contacting the handle. Then,

back off the nut on the link

arm bolt one full turn from the

washer. Handle should raise

and lower freely.

CAUTION: Never put your fingers or hands between the jaws,

or between the jaws and the stake.

Assembly Instructions Operating Instructions

Step 1: Lift handle to up position so that

jaws are fully open.

Step 2: Place unit so that jaws are on either

side of stake. See Figure 1 below.

Step 3: Push down on handle, clamping on

stake and lifting it out of the ground.

Step 4: Repeat motion as necessary until

stake is free

Tip: In soft conditions or mud, place a short

piece (1 to 2 feet in length) of 2 x 4 lumber under

the base of the unit. This will spread the force

over a larger area, allowing stake removal even

in muddy conditions.

Stake Out

Anchor Industries, Inc. ● 1100 Burch Drive ● PO Box 3477 ● Evansville, IN 47733, USA

Phone: 812-867-2421 ● Fax: 812-867-0547 ● Toll Free: 800-544-4445

Email: [email protected] ● www.anchorinc.com

Step 1

Step 2

Step 3

Short bolt

Long

bolt

Link

arms

Step 4

Riser tube

Stake head adapter (optional) (for single head or

shoulder head stakes tamped down close to base plate.) Part #36574

Step 1

Step 1: Remove pin at bottom of

riser tube. Raise the tube until holes

align and replace pin.

Step 2: Fit adapter over head of

stake and slide into small end of slot.

Step 3: Place unit so that jaws

are on either side of stake adapter bar

and continue as noted in Operating

Instructions.

Figure 1

Step 2

Step 3

Stake Out 1

Summary of Contents

Page 1 - Stake Out

ASO 1208Assembly and Operation InstructionsEC 3845Step 1: Place contents of box on floor or table. Place handle over riser tube with de-cal facing

Comments to this Manuals

No comments

Anchor STAKE OUT User Manual

Browse online or download User Manual for Sports and recreation Anchor STAKE OUT. Anchor STAKE OUT User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Sports and recreation Anchor STAKE OUT