Fiesta Catenary Top
Catenary Fastening Assembly
INSTRUCTION SUPPLEMENT
®
Steps:
1. Refer to Standard Fiesta assembly instructions.
2. With top on, pull corners down and pull web over eyebolt. (fig. 1)
3. Place catenary webs with rings through triangular ring as shown. (fig. 1)
4. Place the two short hooks on tension strap into rings as shown. (fig. 2 & 3)
5. Attach long hook on bottom of tension strap to bolt on PTEB as shown. (fig. 2 & 4)
6. When all hooks are fastened, use winch to gradually tension each corner, repeating this process
until top is properly tensioned all around.
7. Do not over-tension. Over-tensioning will result in rafter bending.
FIGURE 1
OUTSIDE VIEW
FIGURE 2
INSIDE VIEW
Eyebolt
Triangular
Ring
Catenary web
with rings
Short hooks on
tension strap
PTCB
PTEB
Long hook on
tension strap
Winch
PTEB
FIGURE 3
FIGURE 4
Upright
PTCB
PTEB
Catenary web
with rings
CTFA-0405
Quality, Craftsmanship and Service since 1892
SALES OFFICES:
1100 BURCH DRIVE
PO BOX 3477
EVANSVILLE, IN 47733 USA
PRODUCTION F
ACILITIES:
BRADENTON, FL
EVANSVILLE, IN
Short hooks on
tension strap
Comments to this Manuals