Anchor NAV50-1204 User Manual download pdf (Page 11)

LIFTING TOP FRAME

(FIRST

SIDE)

INSTALL UPRIGHTS. AT INTERMEDIATE

LOCATIONS, INSTALL UPRIGHT BRACES

AS WELL

UPRIGHT BRACES

USING HEAVY-DUTY NAVI=TRAC FRAME

LIFTS, LIFT ONE SIDE OF FRAME. SLIDE

UPRIGHTS ONTO BOTTOM OF WELD-

MENTS ON THE RAISED SIDE AND PIN.

BE SURE ALL RAFTER AND HIP PINS ARE

SECURE, AS WELL.

INSERT BASEPLATES INTO UPRIGHTS AND

BOLT. NOTE: SQUARE FRAMES AND END

MODULE FRAMES MUST USE FIXED BASE-

PLATES. HINGED PLATES ARE TO BE USED

ONLY ON PIVOTING MIDDLE BEAMS FROM

THE EXTENSION FRAME SETS.

FABRIC LIES LOOSELY ON FRAME UNTIL

UPRIGHTS ARE INSTALLED AND STAKED

LIFT TOP FRAME (SECOND SIDE)

1. LIFT 2ND SIDE OF FRAME TO INSTALL OPPOSITE SIDE CORNER

AND INTERMEDIATE UPRIGHTS.

2. INSTALL UPRIGHT BRACES AT ALL INTERMEDIATE UPRIGHTS.

10-T

10-B

NOTE: BEFORE TENSIONING FABRIC, INSPECT

THE FRAME TO ENSURE INTERMEDIATE

RAFTER, BRACE AND HIP PINS ARE PROPERLY

SEATED IN THE WELDMENT FITTINGS AND

SECURED BY LANYARD PINS.

FABRIC NOT SHOWN

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Anchor NAV50-1204 User Manual Page 11